home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Tommy Walsh's DIY Guide
/
Tommy Walsh's DIY Guide (2001)(Empire).iso
/
hi
/
awruntime
/
t6a.txt
< prev
next >
Wrap
Text File
|
1998-10-05
|
2KB
|
53 lines
Summary
Fitting a new washbasin is quite a major task and several
skills are needed. Read through these steps to learn more:
1 Choosing a location
2 Fitting the taps and the waste outlet
3 Fitting a bottle trap
4 Attaching the basin
5 Connecting the pipes
6 Routing the waste pipes
Tools
Adjustable pliers, heat gun, basin wrench, solder,
drill, screwdriver.
Materials
Basin, taps, waste outlet, supply pipe and fittings,
waste pipes and fittings.
Step 1 - Choosing a location.
The wall must be able to support the basin. Ideally
attach it to a masonry wall. It will also be easier,
in terms of the pipe run, to use an outside wall.
For a plasterboard wall attach to the upright stud
partition supporting the board. You can find these
with a electronic stud partition locator.
Step 2 - Fitting the taps and the waste outlet
It is easier to attach all the fittings to the basin
before you fit it in place. Dismantle the taps and waste
outlet and attach as described in the manufacturerÆs instructions.
The key to fitting a tap is to use the right tools for the job.
In this case, a specialised tap spanner will allow you to get to
those awkward positions.
Step 3 - Fitting a bottle trap
The most modern sort of trap to use is a bottle trap.
Fit this to the waste outlet in the manner shown.
Step 4 - Attaching the basin
Hold the basin and pedestal in position and mark the location
of all the brackets on the floor and wall. Drill the holes and
insert the wall plugs. Attach the basin to the wall and floor.
Step 5 - Connecting the pipes
You are now in a position to connect the supply pipes.
Step 6 - Routing the waste pipes
You will need to plan the waste run carefully. To avoid creating
a vacuum into single waste systems use a waste trap with a depth
of at least 75mm.